possible change of plans. For cost, simplicity and strength reasons I may
just through bolt polycarbonate to replace all the ports. I know this
wont be all that nice in the sense that I will not be able to open the ports
for ventilation. But I am confident this approach would be exceedingly strong
and leak proof.
question is this. I want to use carriage bolts because I think they will
look good from the exterior and their low profile will not be prone to snags.
I wont be able to cut square holes so I want to know if I slightly over
drill the hole just large enough seat the bolt can I fill the area around it
with epoxy? Will epoxy react with the polycarbonate?